18.75.050 Parking space maneuvering dimensions.
(A) Large Vehicle Parking. Certain uses may be required to install large vehicle parking spaces for trucks, buses, and recreational vehicles. Minimum dimension standards for large vehicle spaces shall be 12 feet wide by 45 feet long. Said spaces shall be clearly marked for customer use.
(B) Disabled Parking. All off-street parking areas, other than for single residence uses, shall include reserved spaces for use by disabled persons. Disabled parking, which shall be subject to A.R.S. § 28-882 et seq. shall be provided at a rate in compliance with the adopted building code of the City. Notwithstanding anything in the building code, minimum dimension standards for disabled parking shall be as follows:
(1) Single Space. Sixteen (16) feet wide by 20 feet long. The space shall be prominently striped at 11 feet width of space plus a five-foot access aisle.
(2) Double Space. Twenty-seven (27) feet wide by 20 feet long. The space shall be striped at 11 feet width of each space plus a five-foot access aisle between the spaces.
(C) Standard Parking. The standard parking space shall be a minimum of nine feet wide by 18 feet long unless specified otherwise by this title.
(D) Parallel Parking. A parallel parking space shall be a minimum of nine feet wide by 22 feet long unless specified otherwise by this title.
(E) Loading Space. There shall be provided on the same lot with each commercial building and industrial building or structure adequate space for off-street loading, unloading and the maneuvering of commercial vehicles. There shall be no loading or unloading of commercial vehicles on the public street. Off-street maneuvering space shall be provided so that no backing onto or from a public street is required. The loading space shall be a minimum of 12 feet wide by 45 feet long and a minimum of 14 feet in height. A reduced loading space dimension may be approved by the Zoning Administrator on a case-by-case basis.
(F) Driveway and Aisle Dimensions. Every parking facility shall be provided with one or more access driveways. The minimum dimensional standards for driveways shall be as follows:
(1) Commercial. The minimum width for one-way enter/exit and aisle shall be 12 feet. The minimum width for two-way enter/exit and aisle shall be 24 feet. Additional aisle width may be required depending upon the angle degree of the parking stalls.
(2) Industrial. The minimum width for one-way enter/exit and aisle shall be 16 feet. The minimum width for two-way enter/exit and aisle shall be 32 feet.
(G) Loading docks and service bays shall not front onto an arterial or collector roadway.
(H) Required parking spaces shall be permanently marked. (Ord. 312 § 2(15.4), passed 4-11-2012. Code 2012 § 152.244.)